Packing list 

1 set KSW01

1 set of standard profile jaws at your choice (other type of jaws optional)

1 pcs Allen wrench

1 pcs Scissors

1 pcs Edge cutter

1 pcs Toolkit 

Operation sequence: 

Please read the instructions and warnings before use

1, Select and insert the clamping jaws(9)

2, Turn the Adjustable bolt(5) with Allen wrench to separate the clamping equipment

3,Cut off both ends of the profile to be connected

4,Insert the profile(round belt or V-belt or other type of profile)

in the middle of the clamping jaws(9) and hold it tight with the trigger(6), Tighten the hex bolt(4) with Allen wrench,

Repeat process for other side

5,Keep both ends of the profile with minimal welding gap (<2MM), Notice: lt's not necessary to overtighten the hexbolt(4),

belt slippage in the jaws, Over-tighten can damage the hex Only tighten the hex bolt(4) as require to prevebblt(4)

6,Set the speed switch(2)(steps 1-6)according different type of profile: Small size belt for steps 4~6,large profiles for steps 5~6

7,Set the contact pressure of both ends of profile on adjustment

valve(8):Large profiles from p12mm:Full set pressure(8) Small profiles

8,Press the release button(7)to move the welding jaw together

9, Turn on the power switch(3)

10,When profile swell up, switch off the power switch(3)

11,Welding process is finished, Leave profile clamped for

1-2 minute in the machine to cool off, turn the hex bolt(4)

then move apart with adjustable bolt(5),take out the sealing profile

12,Now the next welding process can be performed

Safety and warning notes:(Please see the following, and in strict accordance with the relevant requirements)

1,Cautionl Dangerous voltage, danger of electrical shock

2,Before the appliance is used, the operating instructions must be read carefully and followed in all aspects

3,The appliance must be stored in a dry and closed area, Keep the appliance dry before use

4,The welding machine may only be held on the handle provided

for this, Touching the welding head during operation must be avoided at all costs

5,The appliance may only be connected to the input

voltage specified on the nameplate

6,Use the machine in large and/or ventilated areas

7,Never use the appliance in an explosive area

8,Switch on the machine only when belt profile is clamped,

otherwise the clamping jaws can be thrown out of the holder

9,Never use the product in a wet area, Avoid the contact to the

device directly with water

10,During the welding process melted welding material can be thrown out of the machine. While operating the machine it

is essential to wear safety glasses and protective long-sleeved clothes (danger of burns).

11,Repairs should only be performed by trained persons.

12,This machine is not designed for continuous operation.

Risk of motor over heating and damaging of the machine.

Technical Data

1,Normal voltage:220V

2,Frequence:50Hz

3,Speed/Min:24000

4, Speedrange:6500-24000

5,Power:600W

7,Dimensians 295x111x100mm

8,Weight:2.5KG